In the area of repaired and damaged drywall, there are a seat lock, a utility knife, a dry low dust joint compound, a dry wall mesh tape, a 1 inch galvanized drift wall screw, a drill, a dry wall knife, dry wall sanding Required block. When working with a joint compound, follow the instruction manual of the product when using it as a design idea.
hole
To repair dry wall holes and small and medium recesses, pull the recesses and carefully remove the loose debris. To get out behind the wall you may need to pull out with wire. The rod can be made from a heavy duty clothes hanger bent at the bottom of the L shape. Carefully fold the indentation forward and gently place the mesh tape over the area. Apply one coat of the joint compound with a smooth uniform stroke using a sparking tool. Dry the joint compound according to the recommendations of the product. Repeat this application until the tape and damaged surface are completely covered. Once it is completely dry, you can smooth the non-uniform part with a damp cloth. When the area has hardened for at least 24 hours, use a sanding block to gently smooth the surface, evenly, use a dry cloth to remove dust from the joint compound and apply paint. Perfect restoration of bedroom and bathroom design where doorknob hits walls.
section
Cut the damaged part of the seat lock with the utility knife to expose the frame stud on the inside of the wall. Complete the raw edge with a knife or sanding block. Please cut out the pattern of the area that needs to be replaced using paper, or save the cut. This makes it easier to measure and cut new parts of dry walls. Once the new piece has been measured and cut, place it in the opening and carefully adjust the edge carefully to fit it. Gently slowly screw the new drywall so as not to damage the drywall. Paste the mesh tape on the raw edge of the joint and begin applying the joint compound with a smooth even stroke according to the instructions above. To cover them, apply a small mass of joint compound to the screw head. Once the joint compound has hardened, paint it with a sanding block and a flat primer coat to smooth the surface and finally apply the matching paint in the design of the bathroom, bedroom, or living room.
Dying and pain
To re-surface a small patch of lightly damaged wall first, lightly "rough" with a sanding block and then remove dust with a dry cloth. Cut the mesh tape so that it covers only the damaged part. Apply the joint compound with a smooth even stroke, allowing curing time and paint. This fix is effective for children's bedroom and game room design.
